Thermal testing of Solar Orbiter

Thermal testing of Solar Orbiter

Released

30/01/2019 4:08 pm

Copyright

Airbus Defence and Space

Description

A side view of ESA’s Solar Orbiter as it entered a vacuum chamber for thermal vacuum testing at the IABG test facility in Ottobrunn, Germany, last month.

The spacecraft flight model had been readied by prime contractor Airbus in the UK. Due to launch in 2020, Solar Orbiter will observe the Sun and measure the solar wind from a minimum of 42 million km away, or less than one-third Earth’s distance. As a result, the spacecraft will be subjected to around 13 times the amount of solar heating that Earth-orbiting satellites experience, and to temperatures in excess of 500°C.

Solar Orbiter’s main body will be protected from direct sunlight by a Sun-facing multi-layer titanium heat shield. The 1.1-m diameter high-gain antenna seen here will be deployed from the body of the spacecraft to, transmit science data back to Earth in high-bandwidth X-band.

The antenna’s black colour is unusual. It is covered with the same kind of protective, high temperature coating as the front of Solar Orbiter’s heatshield, based on burnt-bone charcoal. Developed by Irish company ENBIO, this ‘Solar Black’ coating was selected because it can maintain the same colour and surface properties despite years of exposure to unfiltered sunlight and ultraviolet radiation.

The high-gain antenna is placed at the end of a manoeuvrable 1-m long boom allowing Solar Orbiter to maintain a reliable, high-bandwidth link with Earth throughout its science-gathering phase.

This test campaign – using powerful lamps to simulate the Sun’s radiation – began by simulating the conditions the spacecraft will undergo as it manoeuvres to its operational orbit through flybys of Earth and Venus.

"During 99% of the mission operations time, the heatshield will protect Solar Orbiter, but there will be more than a dozen manoeuvres when one of the side panels will be exposed to sunlight," explained Claudio Damasio, ESA's Solar Orbiter project thermal engineer. "Therefore, we need to know how the Proto Flight Model responds when the exterior of the insulation on these panels reaches a temperature of about 120–150 degrees Celsius."

For practical reasons, some elements, such as the solar arrays and the instrument boom, were not integrated with the spacecraft during the test. They were integrated this month on the spacecraft, which will next undergo a series of mechanical and electromagnetic compatibility tests.

Rate this

  • Currently 5 out of 5 Stars.
  • 1
  • 2
  • 3
  • 4
  • 5
Rating: 4.8/5 (96 votes cast)

Thank you for rating!

You have already rated this page, you can only rate it once!

Your rating has been changed, thanks for rating!

Views

2634