Heat sterilisation of ExoMars parachute

Heat sterilisation of ExoMars parachute

Released

13/03/2019 9:00 am

Copyright

ESA–M. Cowan

Description

A technician places a nearly 70 kg parachute designed for ESA and Roscosmos’s ExoMars 2020 mission inside the dry heater steriliser of the Agency’s Life, Physical Sciences and Life Support Laboratory, based in its Netherlands technical centre.

Mars is a potential abode of past and perhaps even present-day life. Accordingly, international planetary protection regulations require any mission sent to the Red Planet to undergo rigorous sterilisation, to prevent terrestrial microbes from piggybacking their way there.

The Lab’s Alan Dowson explains: “This is the ‘qualification model’ of the 35-m diameter main parachute for ExoMars 2020, basically a test version which allows us to finalise our sterilisation procedures ahead of the flight model chute’s arrival.

“This version has been threaded with thermal sensors, allowing us to see how long it takes to reach the required sterilisation temperature in all parts of the folded parachute, even in the hardest to heat points. Our target was to sterilise at 125 °C for 35 hours and 26 minutes, and the oven took about 44 hours to reach that temperature to begin with.”

The oven is part of the Lab’s 35 sq. m ‘ISO Class 1’ cleanroom, one of the cleanest places in Europe. All the cleanroom’s air passes through a two-stage filter system. Anyone entering the chamber has to gown up in a much more rigorous way than a hospital surgeon, before passing through an air shower to remove any remaining contaminants.

“If you imagine our clean room as being as big as the entire Earth’s atmosphere, then its allowable contamination would be equal to a single hot air balloon,” adds Alan. “Our ISO 1 rating means we have less than 10 dust particles measuring a tenth of one millionth of a metre in diameter per cubic metre of air.”

The mostly nylon and Kevlar parachute, packed into an 80-cm diameter donut-shaped unit, was delivered by Italy’s Arescosmo company. This qualification model will now be sent back there for testing, to ensure this sterilisation process causes no change to the parachute’s material properties.

Alan explains: “We will receive the parachute flight model later this spring for the same sterilisation process – identical to this version, except without any thermal sensors.”

ExoMars’s smaller first stage 15-m diameter parachute has already gone through sterilisation using the oven. This is the parachute that opens during initial, supersonic atmospheric entry, with the second, larger chute opening once the mission has been slowed to subsonic velocity.

The Lab has also tackled a variety of ExoMars instruments and subsystems, but this second stage subsonic parachute is the single largest item to be sterilised. The sterilisation process aims to reduce the overall mission ‘bioburden’ to a 10 thousandth of its original level.

Rate this

  • Currently 5 out of 5 Stars.
  • 1
  • 2
  • 3
  • 4
  • 5
Rating: 4.8/5 (72 votes cast)

Thank you for rating!

You have already rated this page, you can only rate it once!

Your rating has been changed, thanks for rating!

Views

1990